3/29/2024 0 Comments Tube bending instructions chartWhen bending steel sheet or stainless steel the maximum thickness capacity of the machine will be reduced to about 2/3 compared to mild carbon steel sheet. Bending At the maximum operating length and the maximum sheet thickness tubes down to about 1,5 times the diameter of the upper roll can be formed and for thinner sheets down to about 1,2 times the diameter of the roll. The bending is carried out in one operation. The prebent workpiece is introduced from the front and clamped between the upper and lower rolls. By raising the bending roll the workpiece is bent to the required diameter. 3 The workpiece is introduced from the back of the machine and clamped between the upper and lower rolls. As the rolls are asymmetrically mounted the prebending is carried out as per the drawing. Differences in sizes, options and/or accessories may or may not be pictured hereĥ Operation Prebending In order to avoid a flat part at the beginning of the workpiece, it should be prebent first. 4 Operating Instructions 4126 Main components Front side Lower roll Pull-out sleeve for top roll Top roll Handle Hand wheel for bending roll Hand wheel for lower roll Back side Bending roll Cone bending setting Disclaimer: The machine pictured on this page is not necessarily representative of the actual product as delivered.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |